Breather Valve TA296

TA296 Breather Valve

The TA296 breather valve was designed to meet the need for a low-cost, one-way, pressure relief valve.  Standard settings range from 0.5 psid to 3.0 psid reseal or cracking pressure.

The TA296 is tamper-proof and requires no field maintenance. 

Materials and Finish: Corrosion-resistant materials are used throughout.  Housing and hex nut are aluminum alloys.  Standard finish is black anodize.  The standard valve seal and environmental o-ring are made of Buna N rubber, but other materials are available upon request.  Washer is acetal.

Mounting Requirements: Each valve comes complete with a mounting nut, washer, and o-ring.
Mounting hole diameter: 0.58 ± 0.010 (14.7 ± 0.2 mm)
Installation torque: 20-25 in-lbs. (2.2-2.8 Nm)
Maximum wall thickness: 0.290 (7 mm)
Minimum wall thickness: 0
For threaded boss installation: 9/16-32 UNF-3B; no counterbore requirement.


Contact AGM's Engineering department for information on NEMA and IP ratings.

 

TA296 Drawing