| |
The following accessories are available for NEPS 1000 Units. |
| |

|
NEPS Remote Sensor Adaptor NRMS
The NEPS Remote Sensor Adaptor kit provides a means of installing the NEPS dew point sensor in the equipment being purged. If the equipment cannot accommodate the dew point sensor, a sensor block can be provided (sold separately) to allow the sensor to be located closer to the exiting gas of the equipment. The NEPS Remote Sensor Adaptor kit is required to utilize the NEPS dew point stat feature.
|
|
Inline Gas Conditioner (2.2 lbs) BLE1100/80
This is a pipeline dryer that can be used to dry nitrogen gas if the
quality is not known or the gas is not dry for the application. |
|
|
Dewpoint Function Checker (including 5 refills) BLE1100/53
This is a portable hand-held device
that can be used to quickly confirm
the calibration. |
|
|
|
|
Refills for Dewpoint Function Checker BLE1100/0211
These are desiccant refills for the Dewpoint Function Checker. |
|
|
Inter-Connecting Tube (6.5 feet) BLE1100/55
These are inter-connecting tubes that can be used to purge
additional instruments or systems. |
|
|
Dewpoint Sensor (new) BLE1100/155
This is a replacement of the Dewpoint Sensor in the event that
the Dewpoint Sensor in the NEPS 1000 is malfunctioning. |
|
Replacement Exchange Dewpoint Sensor BLE1100/56
When the NEPS 1000 dewpoint sensor's calibration period is about to expire, AGM provides a newly calibrated sensor in exchange for the old sensor. Use this option to avoid downtime for the NEPS. |
|
Continuous Dryer: Voltage 230v 50/60 Hz
BLE1100/57/01
Continuous Dryer: Voltage 110v 50/60 Hz
BLE1100/57/02
These are systems that can be connected to an air supply and
provide continuous dry air to -94˚F dewpoint. Units hold 3 kg of molecular sieve. |
|
Oil Vapor Filter BLE1100/58
This is used with the Continuous Dryer if the air may contain
oil contamination. |
|
Exhaust Line with Flow Regulator BLE1100/70/02
This allows the NEPS 1000 to be used for purging small volumes
by regulating the exhaust. |
|
|
Wall Mounting Gas Bottle Holder BLE1100/73
This holds a gas bottle to a bench or wall. |
|
|
Moisture Trap BLE1100/52
This is an inline absorber for use with
the NEPS 1000 to capture exhausted moisture during purging. |
|
|
Dry Cab BLE1100/77
This is a housing (approximately 13-26 gallons) used
for drying out printed circuit boards and electronic
assemblies using the NEPS 1000. |