- Are these in-line desiccators for use with compressed air?
No, these desiccators are for low pressure applications (up to 5 psi). For high pressure applications see In-Line Desiccators for Compressed Air Systems.
- Can I get different kinds of desiccant in these?
Yes. These units are available filled with molecular sieve, silica gel, or activated alumina. AGM carries a full line of desiccant products and can supply replacement desiccant for desiccators.
- Is there a filter on the inlet/outlet? If so, what size?
Yes, there is a 0.036” perforated plate filter at the inlet and outlet of the desiccator. The purpose of the perforated plate is to prevent the desiccant from escaping the desiccator. Finer filters are available upon request.
- Can I get different end fittings?
These desiccators are available only with 3/4” NPSM threads for use with NPSM or NPT fittings. However, a wide variety of adapters for 3/4” NPSM threads are available commercially that will allow the desiccator to be connected to other types of fittings.
- What materials are the in-line desiccators constructed of?
These desiccators are constructed of UV resistant polycarbonate.
- How do I know which size in-line desiccator to use for my application?
This can be a complicated problem involving flow characteristics and environmental conditions. For recommendations on the appropriate sized in-line desiccator for your application Contact AGM's Engineering Department.
- Can in-line desiccators be refilled?
Unfortunately, these desiccators cannot be refilled. Because these desiccators can be used in pressurized applications they should not be refilled.
|
| |
|
